Nott Products
Serving your Home and Garden needs since 1933


Easy Installation Directions

Three Step Installation

Step: #1 Place unit onto vent pipe after removing the top of the cap ( The part with all the holes. Push down and turn clockwise to separate from the base. Use a needlenose pliars if needed)

Step: #2
Using a rubber mallet, tap the base unit onto the vent pipe. For best results use a blockof wood six inches long (a 2 by 4 is good). Apply the wood block on top of base unit. Using the flat wood block will provide an even accurate fit onto the vent pipe. Tap on the wood block with the rubber mallet tapping into place the base unit onto the vent pipe. For a permanent custom fit apply PVC cement pipe glue inside the base fitting before applying base unit onto vent pipe.

Step: #3 Attach the vent cap onto the base by rotating counter-clockwise to secure and lock the vent cap onto the base unit. To unlock the vent cap top from the base unit, rotate the vent cap clockwise. For best results use rubber-tip needlenose pliers. Insert pliers into the vent cap vent holes to twist vent cap on & off the base unit.

Order a Pipe Guard Now!

© Copyright 2016   All Rights Reserved

No commercial duplication or redistribution allowed without permission of